12PHR/NFX
MODEL SIZES 3kW - 12kW -
other models available on request
Additional to the specifications below. An On/Off switch is provided to control the main power to the heating elements.
Standard Specification
HEATER BODY:
Cast in BS-EN-1561-1997-ENGJL-200 iron, with a heavy fusion bonded epoxy coating impervious to chemically treated pool water, constructed in accordance with British Patent 2.092,282 Design pressure of 35psi (2.46kg/cm2) with 3/4" safety valve(s) set to operate at the maximum normal working pressure of 30psi (2.1kg/cm2) giving protection to both the heater and and the installation as a whole against over pressure. A 1/2" plastic plug at the lowest point allows the heater to be drained at any time. Flow connections consist of easily removable uPVC stub flanges into which the pipes may be fitted using suitable adhesive, as the flanges can be released easily from the heater no unions are required, nor is any form of heat sink needed. Flow direction is from left to right, but may be reversed quite simply on site following the installation instructions.
HEATER ELEMENTS:
Heavy duty Incoloy sheathed elements to BS-EN-60335-1, with low Watt density for long life, are mounted individually in a removable top plate, which allows complete inspection of the interior of the vessel.
CONTROLS:
Heavy duty contactors control the power supply to the elements. The contactors are switched in turn by a filter pump interlock relay, a pool temperature controller with less than 1°C differential, and a manual reset safety thermostat to operate before the temperature reaches 53°C. The control circuit is protected by a 2A fuse. A minimum of 6 indicator lights monitor every stage for simple diagnostic servicing. The controls are mounted in a plastic coated steel enclosure above the heater body. Cable entry is through a removable plate in the rear panel.
MODEL VARIATIONS:
In view of our policy of continuous improvement, we reserve the right to change this specification without notice.
